Инструментальные средства конструкторского проектирования электронных средств. Иванова Н.Ю - 114 стр.

UptoLike

ВУЗ: 

Университет ИТМО | Санкт-Петербург

Составители: 

Рубрика: 

114
Файл Design Rule Check - *.drc
Protel Design System Design Rule Check
PCB File : D:\КПБКС.5159.002.PcbDoc
Date : 28.03.2011
Time : 14:24:24
Processing Rule : Width Constraint (Min=0.25mm) (Max=1mm)
(Preferred=0.8mm) (InNetClass('POWER'))
Rule Violations :0
Processing Rule : Net Antennae (Tolerance=0mm) (All)
Rule Violations :0
Processing Rule : Silk to Silk (Clearance=0mm) (All),(All)
Rule Violations :0
Processing Rule : Silkscreen Over Component Pads (Clearance=0.001mm)
(All),(All)
Rule Violations :0
Processing Rule : Minimum Solder Mask Sliver (Gap=0.04mm) (All),(All)
Rule Violations :0
Processing Rule : Hole To Hole Clearance (Gap=0.254mm) (All),(All)
Rule Violations :0
Processing Rule : Short-Circuit Constraint (Allowed=No) (All),(All)
Rule Violations :0
Processing Rule : Un-Routed Net Constraint ( (All) )
Rule Violations :0
Processing Rule : Clearance Constraint (Gap=0.25mm) (All),(All)
Rule Violations :0
Processing Rule : Power Plane Connect Rule(Relief Connect
)(Expansion=0.508mm) (Conductor Width=0.254mm) (Air Gap=0.254mm)
(Entries=4) (All)
Rule Violations :0
Processing Rule : Width Constraint (Min=0.25mm) (Max=25mm)
(Preferred=0.25mm) (All)
Rule Violations :0
Processing Rule : Routing Layers(All)
Rule Violations :0
Processing Rule : Routing Via (MinHoleWidth=0.8mm) (MaxHoleWidth=0.8mm)
(PreferredHoleWidth=0.8mm) (MinWidth=1.3mm) (MaxWidth=1.3mm)
(PreferedWidth=1.3mm) (All)
Rule Violations :0
Processing Rule : Component Clearance Constraint ( Horizontal Gap =
0.254mm, Vertical Gap = 0.254mm ) (All),(All)
Rule Violations :0
Processing Rule : Pads and Vias to follow the Drill pairs settings
Rule Violations :0
Processing Rule : Hole Size Constraint (Min=0.025mm) (Max=2.54mm) (All)
Rule Violations :0
Processing Rule : Height Constraint (Min=0mm) (Max=25.4mm)
(Prefered=12.7mm) (All)
Rule Violations :0
Processing Rule : Differential Pairs Uncoupled Length using the Gap
Constraints (Min=0.254mm) (Max=0.254mm) (Preferred=0.254mm) (All)
Rule Violations :0
Violations Detected : 0
Time Elapsed : 00:00:00

Страницы