Технический перевод в повседневной жизни. Макеева М.Н. - 55 стр.

UptoLike

ВУЗ: 

ТГТУ | Тамбов

Составители: 

Рубрика: 

Detergent dispenser drawer
This can be removed and cleaned. Just pull it towards you, and leave it under running water for a few min-
utes.
When moving house
When you move, all you need to do is secure the inside of the machine with the transit screws (supplied
with the packaging of the machine) so that it will not be damaged.
Cleaning and special servicing
Hose
Check the hose once a year. It should be replaced if any signs of splitting or damage can be seen. The ma-
chine is under a lot of strain while operating and this may cause a cracked hose to split open suddenly.
Inspecting the drain pump
Your washer has a self-cleaning pump and therefore requires no cleaning or maintenance. Remember how-
ever that small items such as buttons or coins may accidentally fall into the pump. To remove these items, the
pump conies equipped with an "prechamber" which is accessible from the front of the pump. To gain access to
this prechamber simply remove the panel located on the bottom part of the washer, place it on the ground near
the machine and remove the lid by turning it in the counter clockwise direction Carefully inspect the inside of
the pump.
Trouble shooting
If the machine does not seem to be working properly before calling the service engineer there are a number
of things you can check. Perhaps you have forgotten to push in a button or you are not using the machine prop-
erly.
Sympton Correction
Machine won't start Make sure the appliance is plugged to
the mains socket; you have electricity in
your home, the door is firmly shut, the
ON/OFF button D is on I, the
programming cycle knob, in washer
which have one, is on O, the
programme is properly set and the
mains water tap is open
Machine won't fill Make sure the water tap is open and
connected correctly to the hose, the
water mains has not been cut off and
that water pressure is sufficient; also
check the hose for kinks
Окончание табл.
Sympton Correction
Lots of vibration
during the spin
Make sure the internal oscillating unit
was released correctly at the time of in-

Страницы